0.99-inch 40x160 tft display，Rectangular display
0.99-inch strip IPS full-view LCD display, spi interface, using GC9D01 driver IC, full view, can be applied to smaller-sized devices
Main parameters of 0.99inch tft display
| ITEM | Standard value | UNIT |
| LCD SIZE | 0.99 | INCH |
| LCD Type | TFT Negative Transmissive | — |
| Driver Element | a-Si TFT Active matrix | — |
| Number of Dots | 40*(RGB)*160 | Dots |
| Pixel Arrangement | RGB Vertical Stripe | — |
| Pixel Pitch (W*H) | 0.219*0.219 | mm |
| Active Area | 6.096*24.384 | mm |
| Viewing Direction | all view direction | — |
| Control IC | GC9D01 | — |
| Module Size(W*H*T) | 8.6(W)*29.80(L)*1.5(H) | mm |
| Back Light | White LED | |
Download relevant technical documents
GC9D01 data sheet for small lcd display
Specification of 0.99-inch small lcd display
initial code for 0.99-inch small lcd display
Customize the length, width and thickness of FPC or cable, adjust the pin arrangement according to the interface type, and select the appropriate connector. Make your display or circuit board simple and safe with an excellent FPC solution.
A touch screen can be added according to your requirements, there are three options: resistive touch screen, capacitive touch screen, infrared touch screen. Or add protective glass as needed
Display screens with different optical parameters can be designed according to needs, such as brightness, color gamut, response time, gamma and other parameters, and anti-glare, anti-fingerprint coatings, etc. can also be added
The circuit board we designed can convert the interface of your display into an HDMI interface. If your product does not have any display control capabilities, you can use our serial display and only need to use simple commands to control the displayed content through RS232/458
0.99-inch tft display drawings and interfaces
0.99-inch IPS mode tft display, resolution 40×160, backlight with 1 LED lamp, working voltage: 3V, working current: 20mA, the module brightness is 400cd/㎡, the product conforms to Rohs standard, FPC and your motherboard is linked by welding, if you need to change to ZIF or BTB, please contact us.
The outline drawing is as follows:
Interfaces are defined as follows：
| Pin | Symbol | Detail |
| 1 | SDA | SPI interface input/output pin.the data is latched on the rising edge of the SCL signal. |
| 2 | SCL | This pin is used to be serial interface clock |
| 3 | DC | Display data/command selection pin in 4-line serial interface. |
| 4 | RES | This signal will reset the device and it must be applied to properly initialize the chip.Signal is active low. |
| 5 | CS | Chip selection pin;Low enable,high disable. |
| 6 | GND | |
| 7 | VCC | Power Supply for Logic |
| 8 | LEDA | backlight unit power supply |
| 9 | LEDK | backlight unit power supply |
| 10 | GND |
0.99 -inch 40x160 tft display application cases
The 0.99 “LCD is suitable for e-cigarettes due to its slim ratio. Compared to OLED, LCD offer faster refresh rates, richer colors and longer life, all of which can make your products better.
The slim ratio of 0.99 inch LCD is also suitable for the smart wear market, which can make your smart wear products more beautiful than the competitors’ products. At the same time, the production capacity, price and service life of LCD products are greatly improved compared with OLED.
